CHINON ZOOM LENS Specifications download pdf (Page 33)

flash is integrated electronically with the camera body. Set the f/stop indicated on the exposure calculator dial of your CHINON flash to the

corresponding aperture ring on the lens. A few seconds after your CHINON flash is turned to ON position the flash ready-light will

illuminate. CHINON CG-5 has a special viewfinder ready light system which is electronically coupled to the auto flash. When the flash has

reached adequate power, the shutter speed is automatically set to the 1/90 sec. and the flash ready indicator (red LED) will glow signaling

the camera flash are ready to operate (Fig. 47). After the picture has been taken and before the flash has recycled, the camera will

automatically switch to the automatic or manual mode until the flash has once again recycled. In this case, your flash must be set to the

"AUTO" position. Other electronic flash can be utilized with your CHINON CG-5 camera. However, if they do not incorporate a built-in hot

shoe, a P.C. cord must be connected to the "X" synchronization terminal on your C G-5 for proper flash synchronization. Also the shutter

speed dial must be set to 1/60 sec. flash synchronization position (Fig. 48 and 49).

NOTE: When "FP" or "M" type flash bulbs are used, the shutter speed must be set to 1/15 sec. Use of a tripod for low shutter speed

photography is always recommended. Always refer to the instructions enclosed with your electronic flash for additional operating

instructions.

www.orphancameras.com

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39

No comments

CHINON ZOOM LENS Specifications Page 33